1.FDA & ROHS certificate.
2.No limitation with product thickness .Can do deep curing .
3.High temperature resistance (can reach 0~250 degrees ) ,acid and alkali-resistance and aging resistanceÂ
4.Light viscosity and good flowability .easy for pouring operation .
5.Can be cured both at room temperature or be heated
6.Low shrinkage .Not releasing low molecular during cross-linking process .So the volume is constant .The shrinkage rate is less than 0.1%.
7.Favorable tensile and tear strength
8.High temperature resistance ,acid and alkali-resistance and aging resistanceÂ
Operation Instruction for platinum cure liquid silicone rubber for insole
Step 1: Prepare the moldsÂ
Prepare an perfect mold and clean it totally before operation .
Ã¯Â¼ÂNotes: Make sure your molds and operation tool cleaned up totally to avoid uncure problem .
Step 2: Mix part A and part B evenly
Take 100 G part A and 100 G part B and mix them evenly.Â
Ã¯Â¼ÂNotes: Addition cure mold making silicone rubber is two parts flowing liquid, Please follow the step strictly:
1. Weigh the two part exactly by electronic weight.Â
If any part not in exactly weight , it may cause changing of hardness , or even cause uncure problem.
2. Mix part A and part B evenly.Â
Otherwise the silicone rubber will be partly cured and this will give birth to difficulties in your final operation. WhatÃ¢ÂÂs more, the finished molds will meet a short life. All of these will cause a waste of silicon rubber.
Step 3: Vacuum pumping
Without exception, this step takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available.Â
Step 4: Pouring castingÂ
Clean your molds and brush a layer of release agent (detergent or soap water )on your molds .Pouring the vacuumed mixture silicone on your molds.
PACKAGING: 10kg 20kg 25kg or 200kg /drum.
1.It is a kind of non-dangerous goods .This product should be sealed and placed in a cool and dry place which should keep from sunlight and rain.
2.Silicone mold making rubber RTV-2 is an environmentally-friendly liquidÂ Â silicone product,is not easy to burn which can be stored and transported as non-Â hazardous goods.
3.The storage period of this product is 12 months. If it becomes to be more viscosity . stirring it evenly before using it, so that it can function normally.It can be reused after reinspection when it exceeds the storage period.