rtv2 liquid silicone rubber for artificial stone soap molds making

DESCRIPTION:

RTV-2 mold making silicone rubber is generally named as two-part silicone rubber that vulcanizes at room 

temperature.Part A is a flowable liquid ,part B is the catalyst.

FEATURE: 

1.Good characteristics of easy-operation 

2. Light viscosity and good flowability 

3. Low shrinkage 

4. Favorable tensile and tear strength

5. High temperature resistance ,acid and alkali-resistance 

6.High duplication times 

7.Vulcanize at room temperature 

8.Easy for demoulding 

9.No smell ,non-flammable ,safe and reliable 

APPLICATION resin craft plaster/gypsum casting cornice moulds making:

Making molds for 

1. Cultural relic duplication, architectural decoration, statues

2.gypsum,GRC,concrete,resin,epoxy resin,PU products etc

3. Lighting ornaments, wax candles,hand soap

4. Plaster, Gypsum, Cement, Concrete decorations

5. Model design, product exploitation, etc.

6. Artificial stone 

HOW TO USE:

Step One: Prepare and clean the prototype.

You must make sure your original molds perfect. 

Step Two: Mixing part A and part B evenly 

Take 100g of part A and add 2g of part B and mix the silicone rubber and curing agent evenly. 

Step Three: Vacuum pumping

Without exception, this step takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no 

more further steps will be available. 

Step Four: Pouring cast or brushing cast

After released the bubble, we can pour/brush the silicone rubber on the prototype

Pouring cast:

It is suitable for simple products with the smooth surface. Without any mold lines, which helps you save time 

and is easy for operation. Evenly and slowly pouring the mixed silicone rubber into the square frame. After the 

cross linking reaction and the silicone rubber turns dry, you can take the products out. Thus, the mold has been 

done.

Brushing cast:

a. Evenly brush the mixed silicone rubber on the product which is covered with mold spray with a brush or a 

brush pen. 

b. After the cross linking reaction (about 30 minutes), brush a second coat which can increase the tension and 

tear strength of the mold. 

c. Cover a glass cloth on it after another 30 minutes of a second cross linking reaction, and use a brush pen or 

a brush to avoid any interstices.

d. Cover a third coat.

PACKAGING: 10kg 20kg 25kg or 200kg /drum.

STORAGE:

1.It is a kind of non-dangerous goods .This product should be sealed and placed in a cool and dry place which 

should keep from sunlight and rain.

2.Silicone mold making rubber RTV-2 is an environmentally-friendly liquid   silicone product,is not easy to burn 

which can be stored and transported as non-  hazardous goods.

3.The storage period of this product is 12 months. If it becomes to be more viscosity . stirring it evenly before 

using it, so that it can function normally.It can be reused after reinspection when it exceeds the storage period.